-40%
LAMP RETROFIT FOR J&L EPIC-114, EPIC-214, EPIC-130, EPIC-230 & OTHER COMPARATORS
$ 472.56
- Description
- Size Guide
Description
NOTE:PayPal is our preferred payment method. If you or your company do not have a PayPal account PayPal guides you through the payment process using your credit card.
Please use the "Ask A Question" at the bottom left of this eBay listing and we will answer them for you.
We designed the very first mercury arc lamp retrofit in 1972 while working for Waterbury Farrell, Division of Textron, Inc.
We are the World's largest builder of Lamp Retrofits for Jones & Lamson and other model optical comparators and visual grinders.
Our retrofits are being used in North America (Most of the US States, Mexico and Canada), Asia, Australia, Europe, South America and South Africa.
In addition to the thousands of small and large companies including many Fortune 500 and Fortune 100 companies we have serviced over the years our customers include 9 Navy installations in and around Washington DC, Maryland and Virginia, the General Service Administration, the National Security Agency at Fort George G Meade, MD and the United States Secret Service, Laurel MD.
You are buying one THLC-24-350-I 24 Volt, 250 Watt, ready to install replacement Retrofit package seen in picture #3. It is made to replace the Power Supply used on the following Jones & Lamson (J&L) Optical Comparators using P/N 91991:
This retrofit is for Classic-30, Classic-30E, Classic-30S, Classic-120, Classic-220, Classic-130, Classic-230,
Epic-14S, Epic-114, Epic-120, Epic-214, Epic-130, Epic-220, Epic-230, Epic-50, Epic-250 and others.
The first picture is one of our customer's J&L Epic-114 before it was retrofitted.
The second picture shows one of our retrofits a customer installed in one of their J&L Epic-230 comparators.
Installation is very easy and will take about 30 to 45 minutes to complete.
Your comparator has a door on the side of it and the electrics and electronics are mounted on a panel inside the enclosure behind the door.
The T-4 run transformer is removed and our transformer is mounted in it's place using two of the four screws (or nuts) that previously held the T4. The transformer we send is pre-wired and all you have to to do is cut the wires to desired length and crimp the spade terminals (supplied) on the wires and connect to the proper numbered terminal strip. It is not necessary to remove the other items from the old supply as they no longer have electricity in them although we do in our calibration business as it results in a much neater job.
The aluminum plate and 1/4-20 SHCS with plastic knob adjustment screws is removed to take out the SAH-250-B lamp and replace it with our special lamp socket assembly and our 24V-250W lamp inserted in the ceramic holder.
The chimney and cover are put back on. Lamp alignment is performed the same way you did with mercury arc lamp.
The aluminum plate, four screws and plastic knobs are not removed when you replace our lamps.
We send a lamp removal and insertion tool with the retrofit. To change lamps with our retrofit simply remove the condensing lens and using the tool we supply go through the hole in the lamp house and remove the burned out lamp and install a new one without touching the lamp with your fingers.
The tool we send consists of a new fuse puller, secretaries rubber finger tip and Krazy glue.
Each Retrofit comes with a five year Warranty and
FREE BULBS FOR LIFE
.